1986 Giddings & Lewis SC — UMS record #13180
FACING & CENTERING MACHINES
Historical UMS record #13180
Specifications
CAPACITY
Diameter0.5" To 6.25"
Length1 3/4" To 60"
ADDL SPECIFICATIONS
Drill Head Motor3 HP.
Drill Spindle Feed rate (Infinitely Variable)0 To 50 IPM
Max. Feed Stroke36"
Center Drill Capacity (W/Adaptors)1/8" - 1 1/4"
Morse Taper Capacity (W/ Adaptors)#1, #2, & #3
Overall Dimensions114" x 52" x 56" Ht.
Approx. Weight6,400 Lbs.
Equipped With
440 Volts/3/60
Floor Space- 120" x 60"
Control Relay Logic On Standard Push Button Operating Panel
Coolant/Chip Pan
Hydraulic Vise
Work Support
1-Cuter Head
Hydraulic System Vickers Pump
Tailstock w/Live Quill
1 Face And Center Cuter Body Approx. 4" Diameter
(2) 33" Scales
2 Spot Face/Drilling Heads
1 Self Centering Vise w/Electirc 1/2 HP Drive Motor
5/16" Diameter Center Drill Adaptor
2" Diameter Spot Facing Tool
Live Center In Place Of One Cutter Head
Work Pre-Locators
(1) Set-up Of Cutter Speed Change Gears
Hydraulic Unit With Pump, Motor And Plumbing
Hydraulic Control valves For Infinitely Variable Feed Control Rates
Pressurized Hand Pump Lubrication System
Electrical Diagrams
HISTORY
Machine Faced & Centered Constant Velocity Joint Components Out
of 1050 Steel
NOTES
This standard Model SC machine is capable of spotfacing & center-drilling shaft
ends. This machine is equipped with singlr vise and was used by its previous
owner to spotface & center-drill one shaft end only. The cutting head on the
opposite end from the vise holds a live center in place of the centerdrill/spot face
cutter. The machine has been thoroughly cleaned & cycled and found to be in very
good condition.