1991 HydroFlow HVF-24B — UMS record #14696
COOLANT FILTERING SYSTEMS
Historical UMS record #14696
Specifications
SPECFICATIONS
Tank Capacity1000 Gallons
Clean Tank Capacity300 Gallons
Filter Flow Rate110 Gal/Min.
Pressure Flow Rate @150 PSI800 Gal/Min
KOOLANT KOOLERS
Serial Number6311
Main Pump Motor15 HP.
FregonR-22@45 Lbs.
Operating Range+/- 6 To 12 Degrees F
Equipped With
THE SYSTEM
The HydroFlow Rolled Media Vaccum Filter Is A Fully Automatic Filtration System
Specifically Designed For The Metal Working Industry. The Filter System Is Designed
For Contineous Service With Minimal Operator Attention and Provides A Consistant
Quality Of Solids Separation, Maximum Coolant Life and Increase Productivity.
The Principal Of Opertaion:
1) The Bottom Of The Main Holding Tank Is Constructed Of Filter Panels Of
Reinforced Perforated Steel Plate To Support Synthetic Filter Media.
2) The Filter System Pump Draws Fluid Through The Media & Returns It Directly
To The Point Of Use Of Machine Tools. The Pump Handles Only Clean Filtered
Liduid, Which Contributes To Long Pump Life & Low Maintenance.
3) The Solids Retained On The Media Surface Form A Filter Cake. As The
Filter Cake Deepens, The Fluid Path Becomes Restricted,
Removing Finer Particulate & Increasing Effiency Of Filtration.
4) When The Pressure Drop Across The Media Reaches A Preselected
Set Point, The Automatic Regeneration Cycle Is Started.
5) During The Regeneration Cycle, The Vaccum Under The Media Is Dissipated,
Releasing The Media. The SystemPump Now Draws Fluid From The
Clean Regeneration Tank.
6) After A Short Delay, the conveyor "Dragout" Is Activated & Advances
Several Inches ToCarry Media & Contaminants For Disposal. The Dirt Cake
Is Discharged In A "Near Dry"State Because The Solids Remain On The Filter
Inclined Ramp For Several Regeneration Cycles During Which
Excess Liduid Drains Back into The Dirty Holding Tank. At The Top Of
Ramp, Solids Fall Into A Hopper.
Systems Are Now In Operation:
Machining, Grinding, Creep Feed & CBN Grinding & Rolling Mills.
Of Virtually All Materials, Including:
Steel, Stainless, Cast Iron, Aircraft Alloys, Carbide & Composites
Koolant Koolers Cooling System
Voltage: 480/3/60
NOTE
Machining Used On CNC Creep Feed Grinders
(2) Automatic Vaccum Filter Systems Available
REPLACEMENT COST
$99,400.00