1991 Hydroflow HVF-60B — UMS record #14695
COOLANT FILTERING SYSTEMS
Historical UMS record #14695
Specifications
SPECFICATIONS
Tank Capacity2500 Gallons
Clean Tank Capacity900 Gallons
Filter Flow Rate450 Gal/Min.
Pressure Flow Rate @150 PSI240 Gal/Min
KOOLANT KOOLERS
Serial Number6312
Main Pump Motor50 HP.
FregonR-22@110 Lbs.
Operating Range+/- 6 To 12 Degrees F
Equipped With
THE SYSTEM
The HydroFlow Rolled Media Vaccum Filter Is A Fully Automatic Filtration System
Specifically Designed For The Metal Working Industry. The Filter System Is Designed
For Contineous Service With Minimal Operator Attention and Provides A Consistant
Quality Of Solids Separation, Maximum Coolant Life and Increase Productivity.
T
The Principal Of Opertaion:
1) The Bottom Of The Main Holding Tank Is Constructed Of Filter Panels Of Reinforced
Perforated Steel Plate To Support Synthetic Filter Media.
2) The Filter System Pump Draws Fluid Through The Media & Returns It Directly To The
Point Of Use Of Machine Tools. The Pump Handles Only Clean Filtered Liduid, Which
Contributes To Long Pump Life & Low Maintenance.
3) The Solids Retained On The Media Surface Form A Filter Cake. As The Filter Cake
Deepens, The Fluid Path Becomes Restricted, Removing Finer Particulate & Increasing
Effiency Of Filtration.
4) When The Pressure Drop Across The Media Reaches A Preselected Set Point, The
Automatic Regeneration Cycle Is Started.
5) During The Regeneration Cycle, The Vaccum Under The Media Is Dissipated, Releasing The Media. The System
Pump Now Draws Fluid From The Clean Regeneration Tank.
6) After A Short Delay, the conveyor "Dragout" Is Activated & Advances Several Inches To
Carry Media & Contaminants For Disposal. The Dirt Cake Is Discharged In A "Near Dry"
State Because The Solids Remain On The Filter Inclined Ramp For Several Regeneration
Cycles During Which Excess Liduid Drains Back Into The Dirty Holding Tank. At The Top
Of The Ramp, Solids Fall Into A Hopper.
Systems Are Now In Operation:
Machining, Grinding, Creep Feed & CBN Grinding & Rolling Mills.
Of Virtually All Materials, Including:
Steel, Stainless, Cast Iron, Aircraft Alloys, Carbide & Composites
Koolant Koolers Cooling System
Voltage: 480/3/60
NOTE
Machining Used On CNC Creep Feed Grinders
(2) Automatic Vaccum Filter Systems Available
REPLACMENT COST
$187,800.00